Saturday, March 5th, 2022

The dry fit of the overhead storage bins is complete. I had to take the right-hand bin apart four or five times, trimming off bits here and there each time, reassembling it to check the fit, marking places where it needed further trimming, then taking it to pieces again. It has to sit snugly in the window so it doesn’t get in the way of the lid for the rear storage space. Took me about an hour and a half, but I finally got there. The left-hand bin was easier because I already had a pretty good idea where to trim and how much. Only had to take it apart twice.

Now that the dry fit is done, I have to take both of them apart again, sand all the pieces smooth, reassemble them (this time with glue), and finally brush a couple coats of clear polyurethane sealer on them. I never thought about painting them because I like the look of wood grain, even when it’s plywood.

They don’t look like much from this angle, but each one of the bins is large enough to hold as much as those rolly bags you can carry on a commercial airliner. I could pack a week’s worth of shirts, socks, and undershorts in just one of them and still have plenty of room left for toiletries, a book or two, something to write with, and I don’t even know what else. That leaves all the room under the bed for food, utensils, and other essential camping gear.

dry fit | 2:22 pm CDT
Category: camping, carpentry, hobby | Tags:
Comments Off on dry fit

Comments are closed.